The Hydraulic punching machine is composed of manual pump or electric pump and working head. The oil hose is connected by quick connector, which is reliable and fast. There is no directional restriction during operation, and it is easy to assemble and disassemble. This machine is specially used for drilling angle iron, flat iron, copper, aluminum and other metal plates, especially suitable for electric power, construction and other industries in the field
How to use the Hydraulic punching machine:
A connect the oil pump and working head with quick coupling
B select the corresponding upper and lower mold, install the upper mold first and then the lower mold. When installing the upper mold, first screw out the set screw to a certain position and then install it into the lower mold. Be sure to put it in position and then tighten the set screw.
C place the workpiece, close the oil return screw of the oil pump, and move the handle until the oil return screw is released after the work is completed. When punching thin metal plate, the return pad must be inserted between the return tripod and the workpiece, otherwise the workpiece will be stuck on the die.
Operation specification
1. The operators must be trained in safety technology, and the qualified ones can work.
2. The moving parts of the machine will move beyond the range of the base and foot. When the machine is running, no one is allowed to enter the above dangerous area.
3. When the machine is going to work, the operator's hand should not be placed near the die or on the moving platform. The discharging height of the platform shall not exceed 10 cm.
4. During the operation of the machine, it is not allowed to repair and adjust the mold.
Mold replacement method
1. Upper mold replacement method: use the (black) elastic driver to loosen the upper mold (silver white) fixing bolt to the left, slowly remove the upper mold, replace the required upper mold, and then use the elastic driver to tighten the upper mold fixing bolt to the right.
2. Replacement method of the lower die: use a small hexagon wrench to loosen the screw fixing the tightness of the lower die to the left, and then from the bottom of the lower die, use fingers or small tools to push out the lower die from the bottom up, replace the lower die matched with the upper die, and tighten it with a small wrench.
Note: 1. The typing side of the lower die is upward, not downward. 2. When replacing the die, remove the upper die first, so as to replace the lower die.
Technical parameters:
Work efficiency鈮?0 model/min
Overall power18KW
Air consumption0.4-0.8MPacheap Punching Machine
website:
http://www.hebeidiweikeji.com/auxiliary-equipment/punching-machine/